Saturday, October 22, 2011

How to Flash Update/Upgrade Samsung Galaxy TAB P1000 Firmware

Here's the step by step procedure on how to Flash, Upgrade or Update the Samsung Galaxy TAB P1000 Firmware.

Disclaimer: Make sure to select the right firmware version that only match with your region. Firmware versions may varies from countries or regions and or service providers. Do Not Apply this method if you are not familiar with firmwares. This procedure are for advance users only and not recommended for beginners.  Proceed with necessary precautions,... We are not liable if something happens to your phone.

Tools needed in this process:
Samsung Galaxy Tab P1000 Downloader Program:
Download link 1, Download link 2 
 
Driver: Samsung P1000 Galaxy Tab USB Drivers
Download link 1, Download link 2 

USB Data Cable

Firmwares: Samsung P1000 Galaxy Tab Firmwares
P1000XXJH8 - P1000_XXJK5-OXAJK5 - P1000_XXJM6-OXAJM6 - P1000_XXJMA - P1000_XXJMC - P1000XWJMF - P1000XWJMI - P1000JPJM4 - P1000JPJM5 - P1000XWJMK - P1000BUJMC - P1000XXJMG-OXA


Firmware Flashing Steps and Procedures:

1. Run Samsung Galaxy TAB P1000 Firmware Downloader program.

2. Check these: Re-Partition + Auto Reboot + F.Reset Time checkboxes.
     Select PIT file in its field.  


3. Prepare the Device Into Download Mode ( Press Volume Down + Power ON button at the same time).

4. Connect Data Cable To Phone.
The highlighted yellow ID:COM box is and indication that the device is connected properly to PC.

If you still do not get any results, try another USB port on your computer.

5. Start to Flash the PIT file by clicking Start Button. Then wait... Do not touch the phone until  a "PASS"  appears on the left side of the screen is an indication that when the process successfully completes.

6. Click on Reset button, then unselect Re-Partition box. Then select and load the PDA, PHONE and CSC Files each in each desired boxes.

9. Remove the battery, then enter Device into Download Mode again ( Press Volume Down + Power ON button at the same time)., then connect to the PC.

10. Start Downloading PDA, PHONE and CSC files by clicking Start Button. Then wait... The phone will be flashed and once it’s finished, it will boot up. Do NOT disconnect the usb-cable, remove the battery or otherwise interrupt this process! A "PASS"  appears on the left side of the screen is an indication that when the process successfully completes.

11. When the flash download completes... Do Full Reset: *2767*3855#.

0 comments:

Post a Comment